La chasse

Matériels vidéo

Caméras embarquées

Appareils Photos Numériques

Caméras / Caméscopes

Pièges photographique / vidéo

Promotions partenaires

Faire un don au site

Dernières vidéos

Derniers articles

Forum : Masquer l’entête

Accès rapide :

 

Effectuer une Recherche avancée OU


Bushnell HD Agressor, panne ?  [2 réponses]

fred65
starsj1.png
Newbie


avatar
Hors ligne

Nombre de posts: 3 (0.01/Jour)
Inscrit(e) le: 09 décembre 2022

Imprimer Permalien vendredi 9 décembre 2022 à 18:29  

bonjour,
je possede une camera bushnell hd agressor
j'ai essayé de faire une mise a jour et depuis plus rien ne s'allume sur l'ecran pourtant la led rouge en face avant clignote
pouvez vous m'aider?
merci de votre retour
Je ne sais pas insérer une photo donc le n° dans la camera est B160511528 et la version logicielle est BS685BWYx0823F
Merci



 
Partenaire




 
flip
starsj2.png
Visiteur


avatar
Hors ligne

Nombre de posts: 38 (0.07/Jour)
Inscrit(e) le: 26 août 2022
Localisation : Quimper
Activité : Piege photo
Imprimer Permalien lundi 12 décembre 2022 à 20:14  

Il semble qu'il y ait une procédure bien précise à suivre pour la maj d'une Bushnell au risque de bricker la caméra.



 
Tchoa09
starsj1.png
Newbie


avatar
Hors ligne

Nombre de posts: 1 (0.01/Jour)
Inscrit(e) le: 30 novembre 2023

Imprimer Permalien jeudi 30 novembre 2023 à 15:16  

Bonjour,
Je me permet de rejoindre cet échange, car j'ai le même problème, après la mise à jour en suivant la procédure indiquée sur le site Bushnell, : plus d'écran, plus d’accès à la carte mémoire par mon ordi, seule la lampe de détection rouge clignote en set up.
Y a t il une solution ?

ci dessous la procédure buschnell
2017 TROPHY CAM AGGRESSOR
Please read the below instructions completely before starting. Failure to follow the directions will result in a bricked camera that will no longer operate and is irreversible.
Insert an SD card into the computer. If any files exist on the SD card, it is recommended to back up the files and format the card
Copy the “.BRN” and “.ena” files to an empty SD card.
Safely remove/eject the SD card from the computer once the files have been copied.
With the camera turned OFF, put the SD card and 8 fresh batteries into the camera.
Press and hold the ▲ button.
While holding the ▲ button, slide the power switch to SETUP.
A green LED (on the front of the camera) will begin flashing and you can release the ▲ button. The green LED is located in the same location as the Red PIR indicating LED, which will flash as well when motion is detected.
When the Green LED stops flashing, the update is complete.
Turn the camera off, let sit for 5-10 seconds, and then turn back to setup.

You can now setup the camera as normal, but will now have the option to change the camera from dynamic video capture to 5-60 second video clips.

merci



 

Bushnell HD Agressor, panne ?  [2 réponses]